Simple Method for Simultaneous Determination of Selenium and Arsenic in Human Hair by Means of Atomic Fluorescence Spectrometry with Hydride Generation Technique

This study describes a simple, rapid and reliable method for simultaneous determination of selenium and arsenic in human hair by means of atomic fluorescence spectrometry combined with a hydride generation technique (HG-AFS). The procedure developed encompasses microwave digestion of a sample in the nitric acid environment only. The interferences caused by nitrous oxides are eliminated by removing a gas from above the digested solution with a stream of argon. The sample is then chemically treated in a flow-through hydride generation system and exposed to measurements in a double-channel atomic fluorescence spectrometer. The method permits determining both analytes in the linear range of 0.5–100µgL^–1 with a detection limit equal to 0.2µgL^–1, as well as with very good repeatability not exceeding 1% for Se and 2% for As. No mutual interferences from either of the analytes in the concentrations ranges matching the hair composition were found. The method was verified in terms of accuracy with the use of a reference material and then applied to the analysis of the natural samples of human hair.     

Rapid screening of selective serotonin re-uptake inhibitors in urine samples using solid-phase microextraction gas chromatography–mass spectrometry

In this paper a solid-phase microextraction–gas chromatography–mass spectrometry (SPME–GC–MS) method is proposed for a rapid analysis of some frequently prescribed selective serotonin re-uptake inhibitors (SSRI)—venlafaxine, fluvoxamine, mirtazapine, fluoxetine, citalopram, and sertraline—in urine samples. The SPME-based method enables simultaneous determination of the target SSRI after simple in-situ derivatization of some of the target compounds. Calibration curves in water and in urine were validated and statistically compared. This revealed the absence of matrix effect and, in consequence, the possibility of quantifying SSRI in urine samples by external water calibration. Intra-day and inter-day precision was satisfactory for all the target compounds (relative standard deviation, RSD, <14%) and the detection limits achieved were <0.4 ng mL^–1 urine. The time required for the SPME step and for GC analysis (30 min each) enables high throughput. The method was applied to real urine samples from different patients being treated with some of these pharmaceuticals. Some SSRI metabolites were also detected and tentatively identified.     

Laser photoinitiated nitrosylation of 3-electron reduced Nm europaea hydroxylamine oxidoreductase: kinetic and thermodynamic properties of the nitrosylated enzyme

Hydroxylamine-cytochrome c554 oxidoreductase (HAO) catalyzes the 4-e(-) oxidation of NH(2)OH to NO(2)(-) by cytochrome c554. The electrons are transferred from NH(2)OH to a 5-coordinate heme known as P(460), the active site of HAO. From P(460), c-type hemes transport the electrons through the enzyme to a remote solvent-exposed c-heme, where cyt c554 reduction occurs. When 3-60 microM NO* are photogenerated by laser flash photolysis of N,N'-bis-(carboxymethyl)-N,N'-dinitroso-1,4-phenylenediamine, in a solution containing approximately 1 microM HAO prereduced by 3 e(-)/subunit, the HAO c-heme pool is subsequently oxidized by up to 1 e(-)/HAO subunit. The reaction rate for HAO oxidation shows first-order dependence on [HAO], and zero-order dependence on [NO*] (k(obs) = 1250 +/- 150 s(-)(1)). However, the total HAO oxidized shows hyperbolic dependence on [NO*]. We suggest that NO* first binds reversibly to P(460) giving a {Fe(NO)}(6) moiety. Intramolecular electron transfer (IET) from the c-heme pool then reduces P(460) to {Fe(NO)}.(7) The overall binding constant (K) for formation of {Fe(NO)}(7) from free NO* and 3-e(-) reduced HAO was measured at (7.7 +/- 0.6) x10(4) M(-1). This value is larger than that for typical ferriheme proteins ( approximately 10(4) M(-1)), but much smaller than that for the corresponding ferroheme proteins ( approximately 10(11) M(-1)). The final product generated by nitrosylating 3-e(-) reduced HAO is believed to be the same species obtained by adding NH(2)OH to the fully oxidized enzyme. The experiments described herein suggest that when NH(2)OH and HAO first react, only two of the NH(2)OH electrons end up in the c-heme pool. The other two remain at P(460) as part of an {Fe(NO)}(7) moiety. These results are discussed in relation to earlier studies that investigated the effect of putting fully oxidized and fully reduced HAO under 1 atm of NO*.     

Langmuir monolayers of the zwitterionic surfactant hexadecyl 1-N-L-tryptophan glycerol ether

We report the formation of Langmuir monolayers of pure zwitterionic hexadecyl 1-N-L-tryptophan glycerol ether (C(16)-TGE) surfactant and mixed monolayers of cationic-zwitterionic surfactant obtained modifying the pH of the subphase. The pressure-area and surface potential-area isotherms and fluorescence microscopy measurements have been used to characterize the surface phase transitions in the monolayers. These transitions appeared at larger areas as the pH decreased from 6.0 to 2.0 and almost disappeared as the pH decreased further. The analysis of the surface potential and the infrared reflection-absorption spectroscopy data suggests that the phase transition is associated with a change of orientation of both the hydrocarbon chain and the aromatic group of the surfactant with respect to the air-water surface. The surface rheology of the monolayers was studied by quasielastic light scattering and by the oscillatory barrier technique. The results indicate that there is at least one relaxation process in the monolayer.     

Hidden minima of the gibbs free energy revealed in a phase separation in polymer/surfactant/water mixture

We observed a very unusual kinetic pathway in a separating C(12)E(6)/PEG/H(2)O ternary mixture. We let the mixture separate above the spinodal temperature (cloud point temperature) for some time and next cool it into a metastable region of a phase diagram, characterized by two minima of the Gibbs potential, one corresponding to the homogeneous mixture and one to the fully separated PEG-rich and C(12)E(6)-rich phases. Despite the fact that in the metastable region the thermodynamic equilibrium corresponds to the separated phases (global minimum of the Gibbs free energy), we observe perfect mixing of the initially separated phase. The homogeneous state, obtained in this way, does not separate, if left undisturbed. However, many cooling-heating cycles or full separation with visible meniscus above the cloud point temperature induce the phase separation in the metastable region. The metastable region can exist tens of degrees below the cloud point temperature. This effect is not observed in the binary mixture of C(12)E(6)/H(2)O.     

Cu(I) and Ag(I) complexes of chalcogenide derivatives of the organometallic ligand dppf and the dppa analogue

New Cu(I) and Ag(I) complexes were prepared by reaction of [M(NCCH₃)₄][X] (M = Cu or Ag; X = BF₄ or PF₆) with the bidentate chalcogenide ligands Ph₂P(E)NHP(E)Ph₂ (E = S, S₂dppa; E = Se, Se₂dppa), and dpspf (1,1′-bis(diphenylselenophosphoryl)ferrocene). Copper and silver behaved differently. While three molecules of either S₂dppa and Se₂dppa bind to a distorted tetrahedral Cu₄ cluster, with deprotonation of the ligand, 1:2 complexes of the neutral ligands are formed with Ag(I), with a tetrahedral coordination of the metal. The [Cu₄{Ph₂P(Se)NP(Se)Ph₂}₃]⁺ clusters assemble as dimers, held together by weak Se?Se distances interactions. Another dimer was observed for the [Ag(dpspf)]⁺ cation, with two short Ag?Se distances. DFT and MP2 calculations indicated the presence of attracting interactions, reflected in positive Mayer indices (MI). The electrochemistry study of this species showed that both oxidation and reduction took place at silver.     

Mutual Solubilities of Water and Alkanes

Summary.  The evaluation of mutual solubility data for systems water with n-alkanes, isoalkanes, and cycloalkanes along the three phase line is reported and a formula for the prediction of solubility of alkanes in water is developed. Then a cubic equation of state with an added term, which accounts for hydrogen bonding is used for correlation of liquid–liquid equilibrium data and for prediction of solubility of water in hydrocarbons using alkane in water solubility data. Comparison of the predicted and experimental solubilities is performed using all accessible experimental data. With this approach it is possible to predict the solubilities of water in alkanes with good accuracy over the temperature range up to about 20 K below critical temperature. Solubility of alkanes in water can also be calculated using experimental data for solubility of water in alkanes but results of these calculations are more sensitive to experimental errors of the data. Corresponding author: E-mail: macz@ichf.edu.pl Received August 5, 2002; accepted (revised) September 13, 2002 Published online March 13, 2003 RID="a" ID="a" Dedicated to Prof. Dr. H. Gamsj?ger on the occasion of his 70^th birthday anniversary     

The mechanism of thermal decomposition of Co(NO3)2 · 2H2O

The mechanism of thermal decomposition of Co(NO₃)₂ · 2H₂O was found to involve stages in which Co(NO₃)₃ and Co₂O₃ · H₂O are formed both of which decompose to Co₃O₄. During the process, the total cobalt enters the +3 oxidation state, which is consistent with the results reported by Mehandjiev [2].

---

Zusammenfassung Es wurde gefunden, daß der Zersetzungsmechanismus von Co(NO₃)₂ · 2H₂O Schritte umfaßt, bei denen Co(NO₃)₃ sowie Co₂O₃ · H₂O gebildet werden, beides weiterzerfallend zu Co₃O₄. Während des Vorganges erreicht das Gesamtkobalt die Oxidationsstufe +3, was mit Ergebnissen von Mehandjiev übereinstimmt [2].

---

, , CO₃O₄. , .

     

Reactions of lignin in chlorine dioxide bleaching of kraft pulps

The reactions between chlorine dioxide and the residual lignin in oxygen-bleached softwood kraft pulps have been studied. In a first series, isolated lignin samples have been subjected to chlorine dioxide oxidation at different pH values and subsequently analysed by oxidative degradation and elemental analysis. Different analytical techniques have also been employed to follow the gradual chemical changes in lignins isolated from kraft pulps after each of the bleaching stages in the OD(EOP)DD sequence. The results demonstrate that, in order to minimize chlorination of the lignin, the first chlorine dioxide stage should be carried out at a pH around or above three. At this pH level, a high degree of lignin oxidation is also achieved. A certain (mono)-chlorination of the lignin in the first D stage cannot be avoided, but this chlorine is to a large extent removed in the later bleaching stages. The efficient and non-selective oxidation of the various phenolic lignin end groups by chlorine dioxide is clearly illustrated by the analytical data. Moreover,¹³C NMR reveals that reduced lignin structures formed during the kraft cook survive the oxidative bleaching stages to a large extent.